Select the Links tab, or select the Next: Links button at the bottom of the page. This field appears only if you select an Event Hubs namespace first. Select an Event Hubs instance that belongs to the previously selected namespace. You must select a subscription before you can select an Event Hubs namespace. Select an Azure Event Hubs namespace to which you'll send telemetry data for your contacts. In Create contact profile resource, on the Basics tab, enter or select this information: Field On the Contact profile page, select Create. Select Contact profile in the search results. In the Azure portal's search box, enter Contact profile. Prepare the network for Azure Orbital Ground Station integration to configure your network.Ĭonfigure a contact profile for an Aqua downlink mission Sudo mount -t tmpfs -o size=28G tmpfs /media/aquaĮnter the following command to ensure that the Socat tool is installed on the machine: sudo apt install socat This virtual machine is where the data will be written to avoid slow writes to disk. For more information, see Default outbound access in Azure.Įnter the following commands to create a temporary file system ( tmpfs) on the virtual machine. The public IP address here is only for internet connectivity, not contact data. Upload any pertinent licensing material, if applicable.Ĭomplete the Advanced diagnostic information and Support method sections of the Details tab. List Aqua's center frequency ( 8160) and the desired ground stations. In the Problem details section, enter this information: Field Select the Details tab at the top of the page. ![]() Select the subscription in which you created the spacecraft resource. On the New support request page, on the Basics tab, enter or select this information: Field On the left pane, in the Support troubleshooting section, select New support request.Ī Basic support plan or higher is required for a spacecraft authorization request. Go to the overview page for the newly created spacecraft resource. Request authorization of the new Aqua spacecraft resource Select the Review create tab, or select the Next: Review create button. Then, enter or select this information: Field ![]() In Create spacecraft resource, on the Basics tab, enter or select this information: Field A TLE that's more than two weeks old might result in an unsuccessful downlink. ![]() To configure this setting, navigate to your applications’s General settings tab in the Console and check the Enabled box under Skip payload encryption and decryption section.Be sure to update this TLE value before you schedule a contact. Also, scheduling downlinks from The Things Stack will be restricted, as it is expected for downlinks in that case to be scheduled from integrations. This will cause the Application Server to forward messages to integrations without any processing, for example it will neglect payload formatters, meaning the integrations will be responsible for decrypting uplink messages in order to understand them. ![]() Once the application is created, you can update your application settings to skip uplink payload decryption and downlink payload encryption. LoRaWAN® frames are encrypted and decrypted on the application layer using the AppSKey by default. See the CLI Reference for details on managing application API keys using the CLI. You will not be able to see this key again in the future, and if you lose it, you can create a new one by following this same procedure. Make sure to copy the key and save it in a safe place. This API key has only delete rights and can therefore only be used for deleting this application. The CLI will return an API key such as NNSXS.RLA7AGGMD5ZHBH. API_KEY_NAME = "API key for deleting my application" ttn-lw-cli applications api-keys create \
0 Comments
Leave a Reply. |